M14 Propulsion Sub Module No 3 (QUIZ : NO 1)

M-14 Chapter No 3

Quiz

 

1. The igniter can be checked by listening for a snapping noise as the engine begins to turn, driven by the ?
   1.   Engine
   2.   APU
   3.   Starter
2. The energy is stored in which device ?
   1.   capacitors
   2.   resistors
   3.   transistors
3. Which system provides ignition for turbine engines ?
   1.   inductor igniter type
   2.   capacitor type
   3.   inductor type
4. Continuous ignition is used in case the ?
   1.   engine were to start after long storage
   2.   engine were to flame out
   3.   engine were to iniatially start
5. Which winding is used only for starting purposes In starter generator ?
   1.   shunt field
   2.   c field
   3.   a compensating field
6. The starter generator while acting as a starter, makes no practical use of its ?
   1.   shunt field
   2.   a series field
   3.   a compensating field
7. In starter generator the motor relay, ignition relay, and battery cutout relays are closed when
   1.   the battery and start switch is turned on
   2.   the battery is turned on
   3.   start switch is turned on
8. When starting engines with an air turbine starter, prior to the start attempt always  check
   1.   drain oil and service a drive coupling
   2.   oil leakage
   3.   duct pressure
9. Gas turbine engines are started by rotating the ?
   1.   low pressure compressor
   2.   medium pressure compressor
   3.   high pressure compressor
10. The starter generator unit is basically a shunt generator with ?
    1.   an additional heavy series winding
    2.   an additional heavy shunt winding
    3.   an additional fine paralllel winding