M11 Turbine Aeroplane Structures & Systems Sub-Module No 6 (Quiz No:1)

Electrical Power

Quiz

 

1. One means to increase reliability is to ensure ----------- can be used to power any given load ?
   1.   More than one power source
   2.   One power source
   3.   Two power source
2. Most of synchronizing bus systems are less automated and require that ----------- monitor systems and manually control bus contactors ?
   1.   Maintenance crew
   2.   Ground crew
   3.   flight crew
3. Normally, the manufacturer of the electrical equipment specifies the fuse or circuit breaker to be used when-----equipment ?
   1.   Removing
   2.   Installing
   3.   Running
4. Automatic reset circuit breakers reset themselves ?
   1.   Manually
   2.   Automatically
   3.   Thermally
5. Voltage transformers used for stepping up or stepping down ?
   1.   Voltages
   2.   Current
   3.   Frequency
6. An increase in ------ is obtained by reducing the field circuit resistance with the rheostat ?
   1.   Current
   2.   Load
   3.   Voltage
7. Voltage produced in -------, depends on the strength of the magnetic field ?
   1.   Generator
   2.   Alternator
   3.   Battery
8. The armature used in ------ actually contains three coils of wire ?
   1.   AC alternator
   2.   DC alternators
   3.   Starter-generator
9. These are more modern and typically considered to have better reliability and more accurate generator output control ?
   1.   Solid-state systems
   2.   Electromechanical systems
   3.   Voltage regulators
10. This type of controls are found on older aircraft and tend to require regular inspection and maintenance ?
    1.   Voltage regulators
    2.   Solid-state
    3.   Electromechanical

Read More

M11 Turbine Aeroplane Structures & Systems Sub-Module No 5 (Quiz No:1)

InstrumentsAvionic Systems

Quiz

 

1. An aircraft --------------------------------controls the aircraft without the pilot directly maneuvering the controls ?
   1.   Navigation systems
   2.   Automatic pilot system
   3.   Vow navigation system
2. The --------------system moves the control surfaces of the aircraft to perform the maneuver ?
   1.   Autopilot
   2.   Manual mode
   3.   Navigation systems
3. In the --------------, the pilot selects each maneuver and makes small inputs into an autopilot controller ?
   1.   Auto mode
   2.   Manual mode
   3.   Semi-auto mode
4. The --------------system moves the control surfaces of the aircraft to perform the maneuver ?
   1.   Autopilot
   2.   Manual mode
   3.   Navigation systems
5. There are typically a minimum of----------such radios installed on an aircraft for redundancy ?
   1.   One
   2.   Two
   3.   Three
6. Automatic flight control systems encompass autopilot and related systems such as-----------------------?
   1.   Auto land
   2.   Auto throttle
   3.   Both
7. The solid-state nature of the components ……….. Reliability ?
   1.   Decreases
   2.   Increases
   3.   Do not afftect
8. It operates on the principle of balancing one unknown resistor against other known resistances ?
   1.   Ohmmeter
   2.   Multimeter
   3.   Wheatstone-bridge meter
9. Operating an aircraft near the magnetic poles causes what is known as………..?
   1.   Megnetic error
   2.   Compass error
   3.   Dip error
10. The earth’s magnetic field exits the poles ….?
    1.   Directionless
    2.   Vertically
    3.   Horizontally

Read More