M7 Maintenance Practices Sub-Module No 2 (Quiz No:1)

Workshop Practices

Quiz

1 / 10

1. The unit of velocity is ?
   1.   Kg/meter
   2.   Meter/second
   3.   Kg/meter second
2. The unit of luminous intensity is ?
   1.   Mol
   2.   Kelvin
   3.   Candela
3. This is a planned deviation between an actual dimension and a nominal or theoretical dimension ?
   1.   Allowance
   2.   Tolerance
   3.   Dimentions
4. The difference between the upper limit and the lower limit of a dimension is called ?
   1.   Allowances
   2.   Derived dimensions
   3.   Tolerance
5. Dimensions obtained by combining one or more fundamental dimensions are called ?
   1.   Common dimensions
   2.   Derived dimensions
   3.   Fundamental dimensions
6. The SI unit of temperature is ?
   1.   Fahrenheit
   2.   Kelvin
   3.   Celsius
7. The most elementary dimensions, like length (l), mass (m), and time (t), are known as ?
   1.   Derived dimensions
   2.   Common dimensions
   3.   Fundamental dimensions
8. A piece of ……….. Should be kept on the drilling table to protect the machined face when drilling sheet metals ?
   1.   Planed hard metal
   2.   Planed soft metal
   3.   Planed hardwood
9. Most of the tools are manufactured from …………... And are susceptible to corrosion ?
   1.   Stainless steels
   2.   Alloy steels
   3.   Hard steels
10. …… Is responsible for the acquisition and maintenance of his or her own common hand tool set ?
    1.   Each owner
    2.   Shift supervisor
    3.   Each engineer