M7 Maintenance Practices Sub-Module No 8 (Quiz No:1)

Riveting

Quiz

1 / 10

1. To determine the shear strength, the diameter of the rivet to be used must be found by multiplying the thickness of the skin material by --------------------?
   1.   Four
   2.   Three
   3.   Two
2. It has a guide the size of the rivet hole and with the same degree of countersink as the rivet ?
   1.   Dimpling
   2.   Male die
   3.   Female die
3. It is measured between the centerlines of rivets in the same row ?
   1.   Transverse pitch
   2.   Rivet pitch
   3.   Rivet spacing
4. Riveting with a--------------- is a quick method and requires only one operator ?
   1.   Pneudraulic
   2.   Pneumatic
   3.   Squeezer
5. It is the perpendicular distance between rivet rows. It is usually 75 percent of the rivet pitch ?
   1.   Transverse pitch
   2.   Rivet pitch
   3.   Rivet spacing
6. Riveting with a--------------- is a quick method and requires only one operator ?
   1.   Pneudraulic
   2.   Pneumatic
   3.   Squeezer
7. It is the perpendicular distance between rivet rows. It is usually 75 percent of the rivet pitch ?
   1.   Transverse pitch
   2.   Rivet pitch
   3.   Rivet spacing
8. It is a tool that cuts a cone shaped depression around the hole to allow a rivet or screw to set flush with the surface of the material ?
   1.   Hand rivet set
   2.   Countersink
   3.   Bucking bar
9. It is acceptable to replace 2017 rivets of --------------- diameter or less ?
   1.   4/16 inch
   2.   3/16 inch
   3.   3/8 inch
10. Select a drill about ------------------- smaller than the rivet shank diameter ?
    1.   0.005-inch
    2.   0.001-inch
    3.   0.003-inch