M7 Maintenance Practices Sub-Module No 5 (Quiz No:1)

Engineering Drawings, Diagrams and Standards

Quiz

1 / 10

1. To show complete or part representations of functional systems such as hydraulic and electrical systems ?
   1.   Pictorial diagrams
   2.   Pictorial diagrams or charts
   3.   Charts
2. Parts or assemblies of similar shape, but of different dimensions ?
   1.   Collective
   2.   Constructional
   3.   Combined
3. They composed of one long and two short evenly spaced dashes, indicate the alternate position of parts of the object or the relative position of a missing part ?
   1.   Stitch lines
   2.   Phantom lines
   3.   Extension Lines
4. It appear in the title block refer you to the numbers of other prints ?
   1.   Print number
   2.   Reference numbers
   3.   Dash numbers
5. When more than one detail is shown on a drawing ______________ are used ?
   1.   Print number
   2.   Reference numbers
   3.   Dash numbers
6. Zone numbers read from ______________?
   1.   Left to right
   2.   Right to left
   3.   Top to bottom
7. Vertical locations on an airplane are made in reference to the ____________?
   1.   Buttock line
   2.   Waterline
   3.   Datum
8. A graphic representation of an assembly or system, indicating the various parts and expressing the methods or principles of operation is called ?
   1.   Drawing
   2.   Projection
   3.   Diagram
9. _______ diagrams are used extensively in aircraft maintenance and repair manuals, and are invaluable in identifying and locating components ?
   1.   Installation diagrams
   2.   Block diagrams
   3.   Pictorial diagrams
10. In orthographic projection, there are six possible views of an object ?
    1.   Three
    2.   Four
    3.   Six